IEC61032 IP3X Test Probe C試驗指針銷廠家

本試棒是用于檢驗防止人體觸及危險部件的試具。此試具也有用于防止手持工具觸及的防護檢驗。

1.根據GB/T4208-2008、IEC61032:1997、IEC60529:2001及UL等相應條款制作而成。

2.C類試驗探棒（C類試驗針）是進行家用和類似用途電器防觸電保護試驗的必備器具。

技術參數：

1、探棒長度：100mm

2、探棒直徑：2.5mm

3、檔球直徑：35mm

4、手柄直徑：10mm

5、手柄長度：100mm

6、根據IEC61032圖3(Test probe C) 、GB/T4208-2008表6（一位特征數字3）。

三、使用方法：如圖所示，標準試驗指的關節部分不能觸及帶電部件或不能接近危險部件，并且35mm的圓擋板不能進入。

防止接近危險部件的試驗要求中，C、D型試驗探棒需帶3±0.3N N或1±0.1N推力。

注意：不帶推力產品請配合推拉力計使用。

IEC61032 IP3X Test Probe C試驗指針銷廠家

IEC61032 IP3X Test Probe C (Test Probe C)

Article NO.:BND-C

Basic Introduction:

1, According to: IEC61032:1997/IEC60529:2001 AND UL

2, IP3X Test Probe C ( Test Probe C)  is the necessary tool to proceed protecting electric shock test of household and similar electrical appliances.

IEC61032 IP3X Test Probe C試驗指針銷廠家

Technical parameters

1,  Test Probe Length :100mm

2,  Test Probe Diameter:2.5mm

3,  Dam- sphere Diameter:35mm

4,  Handle Diameter:10mm

5,  Handle Length 100mm

6,  According to IEC61032 figure 3 (the Test probe C), table 6 

IEC61032 IP3X Test Probe C試驗指針銷廠家 

Application:

1,  Standard test refers to the joint part can't touch the live parts or close to the dangerous parts, and 35mm circular baffle can not be enter .

2,  In the test requirement for preventing access to the hazardous parts,  Test Probe C/D need to be with push force 3±0.3N or 1±0.1N

Purpose:

This probe is intended to verify the basic protection against access to hazardous parts. It's also used to verify the protection against access with a tool.

Note:For the without force products,please use with the dynamometer.

IEC61032 IP3X Test Probe C試驗指針銷廠家